Calibrate your scanner

キャリブレーションを行うには、ようこそページでService（サービス）をクリックして、サービスモードに入ります。

サービスページでは、ユーザーはスキャナーの接続状況を確認したり、スキャナーの正常動作に必要なすべてのキャリブレーションを実行したりすることができます。詳しくは、サービスのページを参照して下さい。

In this page it will be explained how to calibrate the scanner.

Recalibrate Head

To launch this tool, click on the Head Calibration button;

There are 2 types of calibration:

Recalibration: Fast procedure to update scanner's calibration periodically or to be performed if the scanner is moved to any other location
Full Calibration: More complex procedure to be performed after a mechanical repair

This tool uses the Calibration Kit to carry out a new calibration of the Optical Head of the scanner. The procedure is the following:

Put the calibration kit inside the scanner in the correct position
Select the calibration type from the drop-down menu
In the calibration dialog, select from the drop down menu the exact calibration kit name
Click Start

If the calibration kit name is not available in the drop down menu, the Load New Master Xml button can be used to add a new calibration kit from the appropriate Xml description file.

The calibration procedure is automatic. Once finished, the software will show one of the following messages:

'Scanner Already Calibrated' : the calibration is not necessary
'Scanner Recalibrated Successfully' : the calibration has been completed
'Scanner Recalibration Failed' : calibration has to be repeated

If the calibration was successful, the Axes Calibration starts automatically.

Recalibrate Axes

This tool is used to check the movement system of the scanner. The scanner will scan an object, analyze it, and use this data to calibrate the movement system.

This tool will start automatically after a Head Recalibration or can be started manually with the button.

When the Dynamic Articulation Module is enabled, calibrate the axis with the specific Axis Calibration Object. From that moment on, any recalibration needs to be performed with the same object. Otherwise, axis recalibration will fail.

The software will show an image of the object needed to calibrate the scanner: either the calibration object (if the Dynamic articulation module is active on the license) or a stone model.

Put the calibration object inside the scanner
Click Recalibrate Axis
Click Ok when prompted

The calibration procedure is automatic. Once it is finished, the software will show one of the following messages:

'Axes Recalibration Successfull' : the calibration has been completed,
'Axes Recalibration Successfull, Dynamic Articulation Calibration Failed' : the calibration has been completed, however the dynamic articulation positioning will not work. This message shows when the dynamic articulation module is active on the license, but the scanner has been calibrated with a normal stone model.
'Axes Recalibration Failed' : calibration has to be repeated

Color Calibration

This last calibration, that can be opened by clicking on the icon , allows to calibrate the acquired colors of the scanner to have realistic color results.

To calibrate the colors, hold a piece of paper in front of the cameras, as prompted by the message, and click OK.

It is important that the whole field is covered by the white paper. Take a look at the following pictures to replicate a correct positioning of the white sheet.