Changes

<translate>

After each scanning step, apart for the articulator, the wizard interface presents the '''Image Edit step'''. For this step, the lower toolbar adapts offering selection tools and actions.

{{Screenshot|wizard-edit-scan.png}}

Another edit step is the identification of markers and dies (when scanned using the custom setup and not the multidie).

;{{List button|prevAction.png}} Previous: Goes back to the previous step. Icon not active during the first scanning step.

;{{List button|rectSelTool.png}} Selection Tools: Opens the selection tool panel in which it is possible to choose how to select part of the image. The available tools will be described later in this page.

;{{List button|nextAction.png}} Next: Goes forward one step in the project. This icon is available when the ongoing step is complete or in steps that can be skipped.

[[File:selection-tools.gif]]

As shown in the GIF, these tools allow to select part of the image to edit the object. Four selection tools are available:

;{{List button|rectSelTool.png}} Rectangular Selection: Draws a rectangle that starts from the click point and grows following the mouse; to select, release the left mouse button.

;{{List button|elliSelTool.png}} Elliptical Selection: Draws an ellipse centered in the click point that grows following the mouse; to select, release the left mouse button.

;{{List button|polygonSelTool.png}} Polygonal Selection: Click in two different points to draw a line and a third point to create a polygon. Double click to close the polygon and select all the area inside its borders

[[File:edit-actions.gif]]

These actions allow to modify the selected information. The following actions are available:

;{{List button|cutSelAction.png}} Delete Selection (DEL) : Deletes the currently selected data.

;{{List button|cropSelAction.png}} Crop Selection ({{Inline button|Key_ctrl.png}} + K) : Keeps only the selected data and removes all the rest.

;{{List button|clearSelAction.png}} Clear Selection ({{Inline button|Key_ctrl.png}} + C) : Deselects all the data.

To use the '''Base Cut''' tool, click on the {{Inline button|cutBaseAction.png}} button then, either click on the model or drag the cursor to determin the height of the cut. Click '''Apply''' to accept the changes. Here below an explainatory video.

[[File:cut-base.gif]]

When scanning dies using the custom setup, as shown in the [[Scan|Scan Interface]] page, the dies need to be identified.

{{Screenshot|segment-interface-dies.png}}

The interface shows, a specific main toolbar, a teeth graphic on the right showing the elements that need to be identified. If they are marked in ...

</translate>

{{Navigation|Scan|Align}}