Changes

The first step of any project that as has been set to have both jaws, is the Articulator Scan.

'''For Articulator scan it is not necessarily meant that an Articulaotr Articulator needs to be scanned; the required scan is the acquisition of the occlusion either using the articulator on its specific support or putting the two models in occlusion on the model holder'''

If the user needs to scan an articulator, we suggest to tilt it backwards, to be able to get as much information as possible. This is just a suggestion as not all articulators can be tilted.

The first second step of any project that as has been set to have both jaws, is the Lower Model Scan. All steps, except for the articulator one, include two sub-steps: the actual scan and the edit of the acquired image.

This scan has been performed with the Reference Rim. Everytime the user launches a scan for models, dies or markers and , if the software recognises that the reference rim has not been used the following message shows.

The user can therefore decide wether whether to cancel the scan, put the reference rim on the model holder and start a new scan, or to scan without using the reference rim. For information on the reference rim visit the [[Accessories|Accessories]] page.

This step allows to edit the aquired acquired image; for detailed information on all the available options in this step visit the [[Edit|Edit Tools]] page.

The upper model can still be edited as shown for the lower model. This time, we will edit the image using a selection tool and cuttign wiith cutting with the delete button on the keybord.